The drive mode of this tool magazine is driven by an absolute servo motor, and the advantage is that there is no need to set the origin for switching on and off.

Hello everyone, today I will introduce to you in the lecture hall of Germany: R3DK7 dual servo tool magazine

The drive mode of this tool magazine is driven by absolute servo motor. The advantage is that the switch machine does not need to set the origin. At the same time, this model can also be driven by a general AC motor. From the appearance, the tool magazine is designed to match the drilling machine. The volume is simplified and compact, and the load-bearing load of the column is lightly designed, which reduces the load-bearing load of the machine tool column.

The upper tool compartment and the tool arm are all driven by servo motors, and the tool change is fast, accurate and stable. The advantages of the 30-type drilling and tapping machine equipped with a disc-type tool magazine are that the tool change point of the disc-type tool magazine will be 90-100 mm higher than that of the front-mounted tool magazine. The range of machining applications is even greater.

The disc-type tool magazine can be equipped with a full-cover sheet metal with automatic doors, which will provide better and easier protection than the front-mounted tool magazine. The actual T-to-T tool change time is faster and more stable at 0.8 seconds for the disc-type tool magazine than 1.3 seconds for the front-mounted tool magazine.

This 30-disc tool magazine also has 30 tool positions to choose from. The servo drive of the cam box makes it easier for the machine tool factory to program and set the tool change mode for light and heavy tools. When the light tool is 1.5 kg, the speed of the servo motor is 2250 revolutions per minute. At this time, the rotation of the cam box is 0.8 seconds, and the heavy tool is 3 The rotational speed of the servo motor is 1385 revolutions per minute when it is 1 kg, so the time for the cam box to rotate one circle is 1.3 seconds.

The knife arm adopts a three-stage linkage knife arm, which can quickly replace the buckle grips of BT/CAT, DIN/HSK and other specifications. Only when grasping, the tool will pop out and buckle the knife without direct contact with the tool rod on the main shaft, so the impact and vibration on the main shaft will be reduced, and the bearing of the main shaft will be well protected.

Do you know about the dual-servo tool magazine with 30/20 tool positions on the disc? If you have any questions, please contact us~